Installing openwrt on a mikrotik routerboard

#INSTALLING OPENWRT ON A MIKROTIK ROUTERBOARD LICENSE KEY#
#INSTALLING OPENWRT ON A MIKROTIK ROUTERBOARD LICENSE#
#INSTALLING OPENWRT ON A MIKROTIK ROUTERBOARD DOWNLOAD#
#INSTALLING OPENWRT ON A MIKROTIK ROUTERBOARD MAC#

ON the network adapter, set receive address automatically. Now connect the cable to the second port. After that, the firmware process is complete. If the router has one Ethernet connector, you do not need to switch anything.Дownload it putty.exe ( ) and winscp.exe ( )Д¬onnect to the router using winscp.exe at 192.168.1.1, using the root username and an empty password, copy the rb951ui-2hnd-sysupgrade.bin to the /tmp folder.Д¬onnect to the router using putty.exe, at 192.168.1.1, using the root username and an empty password, run the command sysupgrade /tmp/rb951ui-2hnd-sysupgrade.bin Loading OpenWRT into permanent memoryДЄfter loading OpenWRT in RAM, in the case of firmware of a router with several Ethernet connectors, you need to reconnect the computer to connector 2.

#INSTALLING OPENWRT ON A MIKROTIK ROUTERBOARD DOWNLOAD#

The router will notify you of the download with an audible signal. Restart the router on the power supply.ДЄfter these actions, the router will boot with the standard version of OpenWRT in RAM. If a Firewall message appears that the application is blocked, allow it access to all networks by checking the appropriate boxes in the pop-up window.Д¬onnect to the Ethernet connector 1. Set the address 192.168.1.10 on the computer's Ethernet adapter using standard operating system tools. Next, you need to configure the DHCP / TFTP server to load the OpenWRT image into RAM. First, it lights up, then flashes, then lights up again, then will turn off. Watch the LED that shows the activity of the device (usually ACT or USR). Turn off the power to the router Press the Reset button And connect the power to the router If the router is already flashed on OpenWRT, instead of the actions listed above, do the following: If the firmware attempt fails, they must be performed again. These settings will only be valid for one reboot of the router. System в†’ Routerboard в†’ Settings в†’ Force Backup Booter: Checked System в†’ Routerboard в†’ Settings в†’ Boot protocol: DHCP System в†’ Routerboard в†’ Settings в†’ Boot device: Try ethernet once then NAND Loading OpenWRT into RAM via TFTPД¬onnect to the router using Winbox or the web interface over Ethernet, make the following settings:

Connect to the router that booted from the OpenWRT image in RAM, and write the OpenWRT image to permanent memory.

Loading an OpenWRT image with the extension into the router's RAM.elf using TFTP.

The device firmware consists of two stages:

#INSTALLING OPENWRT ON A MIKROTIK ROUTERBOARD MAC#

Save the matching file name and the router's MAC address (shown on the bottom cover).).

#INSTALLING OPENWRT ON A MIKROTIK ROUTERBOARD LICENSE#

Go to the File menu and copy the license file (named 'RJ15 - ERX5.key') to your computer.

Open the console by clicking New Terminal in the control panel on the left, run the command.

Connect to the router using Winbox or the web interface (more information about the first connection here: ).

To do this, you need to save it before flashing it to OpenWRT.

#INSTALLING OPENWRT ON A MIKROTIK ROUTERBOARD LICENSE KEY#

In the case of firmware with OpenWRT back to RouterOS, you will need a license key (read more ).

Installing openwrt on a mikrotik routerboard